Self-healing shunt compensation power capacitors / High-voltage compensation power capacitor

Description

BSMJ Self-Healing type low voltage shunt capacitor, applied thd advanced ZN-AL complesed metallized film,adopted foreign dvanced production techology techniques.the products is mainly suitable for low voltage electric network to improve power factor, reduce reactive loss, and improve the electric network quality,transmission equipment to increase transmission capacity. The product conforms to the standard requirements of international electrician committee GB12747-2004 IEC60831-1996. The capacitor is suitable for parallel connect with load in AC electric power system with 50Hz or 60Hz, rated voltage 1000V or below it in order to improve the power factor.

1. Compacted and light: Its volume and weight are only 1 / 4 and 1 / 5 of the old productbecause of the using of a new dielectric-metallized poly prop ylene film.

2. Low loss: The real figure is lower than 0.10%, so the loss of the capacitor it self is extremely low, theheat it gives out is little and the rise of temperature is low, so its service life is very long and it can save energy at the same time.

3. Excellent self-healing ability: Damage of part of the dielectric caused by over-voltage can be self-healed quickly and return to normal state. So the reliability is much higher.

4. Safety: In wardly equipped self-discharge resistor and safety equipment. The selfdischarge resistor can automatically discharge the electric energy the capacitor carries. If there is anything fault with the capacitor, the safety equipment will cut off power in time, thus prevent further troubles from happening. So it smuchsafer touse this kind of capacitor.

5. No oil leakage: The capacitor uses advanced semi-soild impregnant whose dripmelting point it above 70℃. There will be no loss of oil during the course of using it. And thus protect the surroundings from being polluted. The capacitor itself dosenot have to run the risk of invalidation caused by oil leakage.

Reference standards	GB12747-2004 IEC60831-1996
Rated voltage	250VAC, 400VAC, 525VAC, 690VAC, 750VAC, 1050VAC
Service conditions	ambient temperature -25℃ ~+50℃ , humidity ≤85%RH, and altitude lower than 2000m.
Rated output	1 100Kvar
Tolerance	-5 +10%
Over current	1.3 × In
Flowing current	200 times rated current
Tolerance	± 3%
Dissipation factor tan δ	With the power frequency rated voltage, tg≤ 0.1% at 20℃.
Withstand voltage	Between terminals 2.15 times rated voltage for 10 seconds, between terminals and container 3k VACfor 10seconds.
Max permissible over-voltage	110% rated voltage.
Max permissible over-current	130% rated current.

Contact Supplier