All dielectric self-supporting aerial cable(LC-ADSS)

 


Note:

A. Only a part of ADSS cables are listed in the table,ADSS cables with other spans can be inquired from Webitelecomms directly
B. Specifications in the table are got on condition that there is no height difference and the installation sag is 1%
C. Fiber count is 2 to 60. The identification of fibers complies with the national standard
D. Fibers,either single mode or multimode, can be used in the cable
E. Specially designed cable structure is available on the request

----------------------------------------------------------------------------------
Discription

ADSS cable is loose tube standard. Fibers, 250μm, are positioned in a loose tube made of a high modulus plastic . The tubes are filled with a water-resistant filling compound. Tubes(and fillers) are stranded around a Fiber Reinforced Plastic(FRP) as non-metallic central strength member into a compact and circular cable core.

After the cable core is filled with filling compound.It is covered with the Polyethylene(PE) inner sheath.After standard layer of aramid yarns are  applied over the inner sheath as strength memeber,the cable is completed with PE or AT(anti-tracking) outer sheath

------------------------------------------------------------------------------------
Features:

* Can be installed without shutting off the power

* Excellent AT performance. The maximum inductive at the operating point of AT sheath can reach 25Kv

* Light werght and small diameter reducing the load caused by ice and wind and the load on towers and backprops

* Large span lengths and the largest span is over 1000m

* Good performance of tensile strength and temperature

* The design life span is 30 years

-------------------------------------------------------------------------------------

Standards:

Comply with IEEE 1222-2004 as well as IEC 60794-1