Sucking tin belt BGA Desoldering Braid Solder Wire BGA absorbtion line

Sucking tin belt and Tin absorption line for the tin absorbing excess solder, CP-3515/3015/2015/2515/1515 BGA Desoldering Wire Solder wick Except for the tin absorbing excess solder.

Sucking tin belt BGA Desoldering Braid Solder Wire CP-3515 3015 2015 2515

BGA absorbtion line 

[ Optional Tin absorption line ]:

Optional 1: CP-1515 -- 1.5mm Width, 1.5M Lenght
Optional 2: CP-2015 -- 2.0mm Width, 1.5M Lenght
Optional 3: CP-2515 -- 2.5mm Width, 1.5M Lenght
Optional 4: CP-3015 -- 3.0mm Width, 1.5M Lenght
Optional 5: CP-3515 -- 3.5mm Width, 1.5M Lenght
Optional 6: Full set CP-3515/3015/2015/2515/1515

Braided Coper Wire Desoldering Wick

WARNING:
Only touch the grip and the pack of desoldering wick when desoldering. Failure to do so will result in serious burns.
To avoid fire, never use a soldering iron and desoldering wick around combustibles or in an explosive environment.

CAUTION:
Do not force the tip against the desoldering wick to avoid injury to yourself and/or damage to the parts and PCB.
Do not heat the desoldering wick for more than 5 seconds to avoid damage to the parts and PCB.

Use:

1. Place the desoldering wick over the solder to be removed, then push the heated soldering iron tip onto the desoldering wick. The solder will be absorbed.
2. Remove the desoldering wick after the solder has been absorbed.
3. Cut off the used section of the wick using nippers.
4. Repeat steps 1,2 and 3 if the solder is not removed completely. Absorbability may differ depending on the type of solder. Sn63% and 60% (tin content) have good absorbability.