5 Layer Anti - Block Screen Mesh Asphalt Batching Plant Auto - Tracking

5 layer Anti-block screen mesh asphalt batching equipment, accurate weighing by auto-tracking

Operating means of asphalt finished product silo:

Manual:

At first, set down the trolley to receiving position, then open the discharging door and the indicator light will shine. After mixer finished discharging process, control the trolley to ascend; the trolley will accelerate to 50 HZ; when the former decelerating switch on discharging door being turned on, the trolley will decelerate from 50 HZ to 12 HZ, and continue ascending slowly; when the upper limit switch of hopper being turned on, the trolley will stop and discharge material to hopper. After discharging process finished, set down the trolley and it will descend and accelerate to 50 HZ freely; when the former decelerating switch on bottom being turned on, the trolley will decelerate from 50 HZ to 12 HZ, and continue descending slowly; when the lower stop switch being turned on, the trolley will stop. This process is a working cycle, and it can repeat.

Automatic:

At first, set down the trolley to receiving position, and then open the hopper covering-door and the door heater. Turn on the automatic button; press start button, and the indicator light will shine to show the system is on automatic state. After mixer finished discharging process; the trolley will accelerate to 50 HZ; when the former decelerating switch on discharging door being turned on, the trolley will decelerate from 50 HZ to 12 HZ, and continue ascending slowly; when the upper limit switch of hopper being turned on, the trolley will stop and discharge material to hopper. After discharging process finished, the trolley will descend and accelerate to 50 HZ freely; when the former decelerating switch on bottom being turned on, the trolley will decelerate from 50 HZ to 12 HZ, and continue descending slowly; when the lower stop switch being turned on, the trolley will stop. This process is a working cycle, and it can repeat.

System stops

When it is needed to stop the facility, stop cold material feeding first. Then stop the operation of burner; stop mixing process; press electromotor stopping button, the system will stop one by one from rear to front according to preset procedure. After the plant stop process finished, shut down computer and console.

Notice

After the whole facility stops, the chief power supply should be shut off.

Lower sprocket wheel Lifting chain and hopper

Lifting chain and hopper