Hypertherm HPR130 Consumables Shield 220764 For Hypertherm HPR260XD Plasma Machine

Hyperther Cutter Consumables Shield 220764 For Hypertherm HPR260XD Plasma Machine
 
1. HEC Brand, We make metal cutting system and plasma cutter as well as torch and consumables. We make plasma cutting machine and fiber laser cutting machine with high quality and reliablity.
 
2. Cut Performance, HEC plasma consumables use high quality material and standard process to make sure the highest quality. Our consumables cutting performance is as the same as orginial OEM manufactory.
 
3. Good Price, HEC plasma consumables are good quality with low price make customers best requirement and saving money.
 
4. Big Catagory, HEC sell all kinds of plasma consumables include Hypertherm, EASB, Kjellberg, Koike and also supply some torch.
 
Our company produces :
2. Kjellberg consumables for HiFocus80i, HiFocus100i, HiFocus130i, HiFocus160i, HiFocus280i, HiFocus360i, HiFocus440i and so on.
3. Esab consumables for PT-25, PT-36, PT-37, PT-600, PT-15XL, PT-19XL, PT-31XL and so on.
4. Koike consumables for SUPER 400, SUPER 400 PLU.
5. Komatsu plasma consumables for 30KW, 60KW 3082, 3084, 3086, 6082, 6084.

 

 
 
 
Technical Support:
plasma cutting arc fault analysis
 
5. earth wire and workpiece contact
 
Grounding is an essential preparation before cutting. Without special grounding tool, the workpiece surface with insulation and long-term use of aging serious ground wire, etc., will make the earth and the workpiece contact. Solution: use a special grounding tool, and check whether the insulation effects of the ground and the workpiece surface contact, avoid the use of aging grounding wire.
 
6. spark generator can not automatically cut off
 
Plasma cutting machine work, first of all to ignite the plasma arc, by the high frequency oscillator excited gas between the electrode and the inner wall of the nozzle, resulting in high-frequency discharge, the gas ionization and the formation of local small arc, the small arc by compressed air, ejected from the nozzle to ignite plasma arc. This is main task spark generator. Under normal circumstances, the working time of the spark generator is only 0. 5 ~ 1s, can not be automatically cut off the reasons for the general control circuit board components, the discharge electrode gap between the spark generator is not suitable. Solution: should always check the spark generator discharge electrode, so that the surface is smooth, timely adjustment of the discharge electrode gap of the spark generator (0. 8 ~ 1. 2mm), if necessary, replace the control panel.
 
7. other
 
In addition to the above reasons, the cutting speed is too slow, cutting the verticality of the torch and workpiece, and the operator of the plasma cutting machine familiarity, the operation level and influence the stability of the plasma arc, the user should notice in these aspects.