High performace Electrolytic Ground Rod / electrode for earthing system

High performace Electrolytic Ground Rod /  electrode for earthing system

FEATURES          

1. Thickness no less than 0.25mm

2. Tensile Strength than 580N/ mm2

3. Straightness error less than or equal to 1mm/m

4. At least 50 years service life

5. Easy installation and low construction cost

Instruction of Use

1. Drilling

Dill the hole about 140mm×3500mm on the earth , or dig the channel about 300mmx3500x800mm and install the grounding rod . Multi grounding rods should be connected by the channel 350mmx600mm.

2. Install the ion grounding rod and connect lead wire;

Remove the seal tape of water absorbing hole and releasing hole (Must );

Put the electrode into assy hole;

Connect the lead wire with anti-corrosion bolt and welded with exothermic welding;

If grounding grid is needed with multi grounding electrodes , 95mm2 copper stranded wire or galvanized round wire or galvanized tape is recommended to connected with exothermic welding.

3. Fix bentonite and water and fill

Fix bentonite and water with the ratio 1:1;

Fill the bentonite and about 50mm higher than electrode , and stir with stick to exhaust the air;

Check the connect the refill the soil ,no stone ,stick or plastic piece left.

4. Test the resistance

Test the resistance 3 days later after installation , and retest one month later and six month later to observe the change.