200 mm Electronic Digital LCD vernier calipers Electronic Digital Vernier Caliper

200 mm Electronic Digital LCD vernier calipers Electronic Digital Vernier Caliper
 
Specifications:

 
Description:
 

Resolution: 0.01mm

• Repeatability: 0.01mm (Quantizing error excluded)

• Power supply: Button-type silver oxide battery SR44(No.938882), 1 peace supplied 

 as standard (The standard supplied battery is for the monitor.)

• Battery life: Approx. 3.5 years under normal use

• Maximum response speed: Unlimited

 
ABS (absolute) measurement function: Enables absolute-mode measurement to be started
 without any zero-setting after switch-on. The absolute origin position can be set, or reset,
 with the ORIGIN switch at any time.
INC (incremental) measurement function: Enables the display value to be set to zero,
temporarily, at the current slider position to enable easy incremental-mode measurement.
Low battery alarm: Indicates (with a “8”symble in the display) that the battery needs replacing.
 This allows timely battery replacement before the caliper becomes unusable.
External output function: Allows measurement data to be exported using the optional data cable.
Hold function: Allows a display value to be held using the optional Data Hold unit (This function
cannot be used along with the external output function.) 
 
 
Instructions for use:
 Before use, release sturdy screws, pull the balance of the foot box with a silk cloth or tissue paper, measuring surface, the guide surface wipe.
 Check the "zero" bit: nudge foot box, two measurements of the outer claw face merger, The cursor "zero" engraved lines and tail engraved lines at this time should be aligned with the groove of the ruler "zero".
Measurement, should be balanced push, pull foot box, so that the two measurement surface of the workpiece surface fitting, should not have used the reading, the eyes should look squarely at the surface of the engraved lines to avoid parallax.
measure the diameter size, the two outer side and the surface of the workpiece to be measured should be fit.
Measuring the diameter size, within claws should be measured in the direction of the diameter of the hole.
measure the depth dimension, so that the ruler end of measuring surface with measurement objects workpiece fit, while measuring the vertical face of the end of the deep foot rod workpiece.
Reading method: read first trip marked "zero" bit-foot body scale the integer (mm); Read Traveling standard ruler scale engraved lines aligned cell number, the small value multiplied by the number of cursors worth, and then adding two numbers can.
 
Note:
Do not use calipers to measure movement or overheating object.
Do not put the caliper two claws as a wrench,, or dosage claw tip to do the marking tool.
mobile foot the box should loosen sturdy screws.
Caliper use completed, must Kaijing the amount of surface and oil antirust into the box.
the caliper storage should avoid magnets, heat and corrosive environments.
 
 
 
Competitive Advantage:
 
Yuyao Yilong Tools Co.,Ltd. is specialized in measure tape, knife and kinds of hand tools. 
 
With more than 20 years experiences in the field of tools industry, it’s our pleasure to provide you with high quality measuring tools.
 
As for measuring tool , below are the main features: 
1)  Made of stainless steel or carbon steel
2)  Four way measurement(OD,ID,Step,Depth)
3)  Main scale and vernier scale are chrome plated
4)  Heat-treated main scale and hardened measuring plane
5)  Special requirements can be customized
 
Our products are exported to America, Europe, Africa and Southeast Asia. During the process of development 

and innovation, we have continuously pursued high quality and high standards, establishing favorable and 

long-term cooperative relationships with many customers.
Welcome to your inquiry!