Description:
Type: |
Mini HVLP Gravity Feed |
Nozzle size: |
0.8-1.0 mm |
Air Consumption: |
1.6-4.0 cfm |
Inlet Air Pressure: |
50-70 PSI |
Maximum Pattern Width: |
100 mm |
Material Capacity: |
100 ml / 4 floz |
Compressor required: |
2-3HP |
Air inlet: |
1/4" BSP/NPT |
Feature:
Standard: OHSAS1 (European Occupational Safety and Health Standards)
Nozzle Size: 0.5mm/0.8mm/1.0MM
The size of the spray rate: about 60CM -120(cm)
Spraying distance: 18 ~ 24CM (cm)
Recommend spraying air pressure: 2.5~ 3.0bar (bar)
Air consumption: 275 l / min (2.0 bar)
Low air consumption: (32% lower than HVLP, 20% lower than conventional spray gun)
Material: aluminum alloy forged chrome Barrel
Weight: 0.5KG (packaged 0.6KG)
300 LVLP spray gun perfect ergonomic design perfect coating spraying effect savings paint, reduce the rate of spraying oil mist attached higher! Harsh hand spray test, the the efficient automobile surface coating best choice!
ST-MINI2008 MiNi HVLP Spray Gun HVLP Gravity Feed 0.8mm Nozzle 125ml Plastic Cup :
How to use:
1. Preparations
Before using the gun gun body intake interface connected compressed air source (compressed air into the gun has to go through the oil-water separator filter), connect the trachea, adjust the air pressure 0.45-0.5Mpa pressure.
2 loading
Coatings with appropriate diluent and mix thoroughly (directly buy mixed paint not need to add diluent) and adjust the viscosity the "coated No. 4 Ford cup 17-24S (cup leakage finished paint time), impurities paint needs filter paint and then import the paint tank.
Pattern regulation
The fog amplitude adjusting screw clockwise rotation until tightened, the obtained circular section Pattern, if it has rotated counterclockwise, can be obtained that you requested oval shape (fan-shaped) cross-sectional width of the mist increases, and according to actual needs adjust the length.
Gun spray volume adjustment
The discharge amount adjusting screw clockwise rotation, so that the pin plug to reduce the opening stroke, the amount of paint out decreases, rotates counterclockwise, the discharge amount is gradually increased.
5 gas regulator
Gas regulator screw clockwise rotation, the gas is gradually reduced, is rotated counterclockwise, the gas is gradually increased.
6 Use
Move the trigger when you use a little, so that the valve is open is not open, but the pin plug, compressed air is ejected from the gas stream nozzle, you can blow off the dust of the painted surface, and then continue moving the trigger back and spray material mouth spray paint mist.
8. Cleaning and conservation
After use, leftover material of the paint tank drained clean cleaning throughout use adapt thinner, tolerance, agent, spraying paint and thinners added tank to clean the paint channel until the gun clean paint Road far , I paint or paint Road left the gun will dry up congestion, damage to the spray gun, cleaned it can be wiped away with a clean, soft cloth.
9 Note
Unavailable sharp wire pass spray nozzle and the air flow nozzles orifice otherwise cause damage to the normal spray.
10 spray gun cleaning may not be a long soak in the diluent.
11 The spray gun parts are made of aluminum alloy and brass should not be contact with strong acidic alkaline medium, to prevent corrosion damage.
The adjustment of the gun is mainly two main interrelated factors: that the adjustment of the gas and the amount of paint.