Vest For Men With High-Tech Electric Heating System Battery Heated Clothing Warm OUBOHK

Size:S,M,L,XL,XXL,XXXL

Carbon fiber heating film:three pieces

Battery:1 block capacity 4400mAh, voltage 7.4V

1.Heating film can emit far infrared, promote blood circulation, beneficial to health

2.Heating fast starting, 5 seconds can feel fever.

3.3 gears can be adjusted freely, convenient and practical.

4. Low loss, continuous working time is 4-8 hours

5. The heating system can be washed with water, gently rub, not easy to damage, long service life

6. 7.4V micro working voltage, and has access to relevant safety certification, no security risks.

7. Fashion design, using the finest cloth production, fine workmanship

8. 1 years warranty, eliminate the consumer any worry.

Manual OF Heated Clothing

1  Operating principle

The lithium battery DC output (voltage and current) connecting line pressure to heat carrier heating carrier directly to the two ends by the temperature control switch, then electric energy transform to heat energy.

2  The use effect

2.1 Lithium battery 7.4V4400mAH boot 5 minutes for pre heating temperature 70°C-75°C

2.1 The red shift with time 4 hours , temperature 55°C-65°C

2.2 White gear using time 6 hours and 30 minutes , temperature 45°C-55°C

2.3 The blue shift with time of 8 hours and 10 minutes , temperature 40°C-45°C

3  Instructions for use

3.1 Put the lithium battery into the waist pocket and plug heating carrier of the clothes, power plugs (DC plug)

3.2 Putting on clothes, switch on the battery (ON/OF) select the gear H , meanwhile press the button the temperature control switch 1 second , temperature control switch LED was lit, to complete the operation.

3.3According to the actual temperature needed, adjust the heating clothes switch gear.

3.4Rated voltage :7.4V DC     battery capacity:4400mAH

3.5 Rechargeable battery life: Charge and discharge ≥ 500 times

3.6The battery working time according to different temperature gear, within 4-6 hours

3.7 The battery runs out after stopping heating work, remove and fully charged the battery to be used next time

4  Charge description

4.1 the charger output plug insert the lithium battery input plug.

4.2 Connect the charger on alternating current, the charger indicator light stable bright red.

4.3 When the battery is fully charged, the indicator light turns green, then remove the battery and unplug the AC charger plug. (recommendations; charging indicator light turn green, continue to charge for an hour, in order to achieve the best effect of charging)

5  The washing instructions

5.1 Remove the battery, the clothes into the water, adding neutral detergent, hand wash, dry cleaning, do not force rub, is not strong to throw the water & drying after washing, in ventilated place to dry naturally.

5.2Don't rinse

5.3 The washed clothes hung vertically, air dry, determined to dry before use.

6  Matters needing attention

6.1 Heating clothing long time not use it, must remove the battery.

6.2 The battery is not used to charge once every 2 months, ready for next time use.

6.3 The battery needs to be properly kept, not be placed in direct sunlight, or damp place.

6.4 Heating clothing washing shall not use high temperature water, alkaline or acidic detergent.

6.5 Do not use strong water washing or hand rub.

6.6 must take the battery out when wash the cloth.

6.7Heating clothing if get wet please turn off the power immediately, stop working.

7  The temperature control instructions (UR-24- military grade)

7.1 The input voltage: 7.4V

7.2input current 3A

7.3Power 10W

7.4Gear; high, Middle, low

7.5 Standby loss: 20UA

7.6 Operating temperature range 80 ° -  -40 °

7.7 Waterproof grade (IP) limit parameter 68

7.8 press switch for a second, should immediately start, warm-up, 4 red light flashing, current meter refers to the 1.3A position, 7.4V DC input voltage, load of 5.8 ohm, output current is 1.3A, 5 minutes after the end of automatic preheating, into the middle class. (when the preheating not ended, press the switch will enter the high gear)

7.9 When Preheating not ended, light press the switch once, 4 red light is on, ammeter shall be referred to in (1.35A) input 7.4V, the load of 5.8 ohm. the current table will swing, 3 seconds in the high level, a second finger in the 0 position. (High-grade)

7.10 Lightly press the switch once, 4 white lights immediately full bright, ammeter shall be (1.35A, 7.4V input, load of 5.8 ohm). the current table will swing, 1800 ms in the high level, 2200 MS in 0 position. (MID)

7.11 Tap again, 4 blue light immediately full bright, ammeter shall be (1.35A, 7.4V input, load of 5.8 ohm). the current table will swing, 1200 ms in the high level, 2800 MS in 0 position. (low)

7.12 Again at the touch switch, at this time will enter in, high, middle, low function of circular gear. (only a reboot will enter the preheating state)

7.13 press the switch one second, at this time should be immediately shut down.

8  The composition and technical index of heating carrier

8.1 Heating carrier with 3 heating plates, 2 small pieces placed in the waist two ribs, 1 large placed in the back middle, 3 pieces of a series connected to form a complete heat carrier, the end of the wire connected with a temperature control switch, is placed in the front left hem fixed, a temperature control switch leads DC power supply plug to the left the battery is connected to the battery pocket.

8.2 heating plate has 1 main heating sheet (170mm * 170mm) and 2 auxiliary heating sheet(120mm * 80mm)

9  The main technical indexes of the battery

9.1Voltage; 7.4V, current of 1.35A, power 10W

9.2 Lithium battery size of 23mm * 93mm * 74mm

9.3Nominal voltage; 7.4V

9.4The nominal capacity: 4400mAH±100mAH

9.5The standard charging time:3-5hours

9.6 Charge and discharge times (0.5C, 0.5C) ≥ 500Times

9.7 Short circuit test, no explosion without fire

9.8 Drop test, no explosion without fire

9.9 Prick test, no explosion, without fire.

9.10 The storage environment temperature of the battery, -20 °C to 40 °C; relative humidity below 95%.