steel eye bolts ,lifting bolts

Ring nuts, eyebolt screw  DIN 580 


1. Feature: 

Forged Eye bolt, Lifting Eye Bolt, DIN 580 Eye Screw 
Surface: Galvanized, zinc plated 
Material: Carbon steel C15, C15E 
Size: M6-M100 
Packing: Carton +Pallet 



2. Products introduce: 

Taking into account a high safety factor in relation to the minimum breaking strength, the ring bolts according to DIN 580 and the ring nuts according 
To DIN 582 have the load-bearing capacities as indicated in table 1. The load-bearing values apply for steel C15 E and stainless steel A2/A4 without 
Restriction in a temperature range of 20 ° C to +200 ° C. 
Ring bolts and ring nuts are valid according to the 2006/42/EC Machinery Directive as load-carrying equipment and are subject to CE labelling. 
Furthermore, they must show a specication of the minimum carrying force (WLL) as well as the specication of the material if required for safe usage. 
The version of DIN 580-2010 and DIN 582-2010 not yet published at the time of printing of this catalogue also prescribes that a marking of an arrow be 
Present in the direction of the axis (picture 1) so that the user can tell that the WWL specied on the product only applies in the direction of the axis. 
Subsequent colour-coded marking of ring bolts and nuts (especially in red) is to be avoided so that they do not get mistaken for high-strength suspension 
Points 




User information for lifting eye bolts DIN 580 
Eye bolts conforming to this standard are primarily intended as permanent attachments on equipment such as motors, control cabinets, gear boxes, 
Etc. When used as temporary attachments on larger objects such as large tools for transportation only, the next largest thread size should be used. 
The safe working load values given in table 1 are based on the following assumptions: 

The capacity specied in the second line of table 1 applies up to an inclination angle of 45° . The capacity specied in the third line applies for laterally 
Inserted eye bolts applies up to an inclination angle of 45° In all directions in regard to the ring level. Lateral pull should not be applied (see picture 2). 
Before being used, eye bolts should be checked for correct seating and apparent damage (e. G. Corrosion, deformation). Deformed eye bolts should be 
Discarded. In eye bolt assemblies with clearance hole, a washer and nut (not thin nut) should be used.