200W led flood light 200W led flood light with Bridgelux COB 45mil LED

Product basic parameters:
1.Product Name:200W led flood light / LED floodlight
2.Power:200W
3.LED: with 4pcs 50W COB LED
4.Light output:90-100lum/W
5.Driver:Meanwell
6.Input voltage:85-265V AC
7.Size:400*340*187mm
8.  Bridgelux COB 45mil LED (G2 Chip)
9.CRI: Ra=70-80 popular; CRI90-95 available
10.Power Factor: >0.95
11.Outdoor Application: IP67 qualified
12.Life Span: 50, 000 hours
13.Warranty: 3 years
14.Certification: CE, RoHS
15. Color Temperature: 2700-7000K available
16 .Life:50, 000h

Product Features:
lamps made of high quality aluminum alloy, stainless steel and die-cast lamp body as a whole, unique shape, direction and angle can be adjusted;
lamps with glass and rubber, silicone seal, internal epoxy potting, with good waterproof performance;
imported light low efficiency, high luminous flux, color and strong, life can reach 50,000 hours;
Built-AC85V-265V/AC110V/AC227V wide voltage constant current driver, make sure the lights work properly in different national, regional or voltage instability, another low pressure DC12V/DC24Vdrivers to choose from.
Lighting Control: monochrome effect (red, green, blue, yellow, white, warm white); internal synchronous RGB color changes; outside the control of synchronous RGB color changes; national standard DMX512 protocol control system;
Protection grade: IP65.

Application
* Road, Street, Bridge, Highway, Expressway, Viaduct, Intersection/Crossroad.
* Parking area, Footpaths, Squares, Villa, Campus, Hotel Garden.
* Dock, Yacht club etc.

Installation method:

1, in the position you need to install three Φ10mm drill hole depth 100MM, as shown in Figure 1;

2, M8 * 80MM expansion screws into the drilled hole and tighten well, shown in figure II;

3, the level of investment M8 * 80MM screw drill holes and wall light bracket screw holes on the expansion of the alignment, shown in Figure 3;

4, the Spotlights cast the mounting position and verify that the installation firm, shown in Figure IV;

5, the lighting fixtures to the correct position of the rotary and fixed, then market power, thus the installation is complete, as five shows.

Installation instructions Notes :

1.LED flat drill Spotlights input line 3-wire power cord, which then Fire Wire red, blue line zero line, yellow line ground wire.

2 more than the rest of the installation in accordance with the installation to install, be sure to tighten the screws, to prevent the loss or rotate the installation process to keep the drill level LED Spotlights balance.

3 When external power cord, must take appropriate waterproofing, leakage measures.

4 The lamp does not violate any laws when using fire.

5 Make sure the maintenance has been powered down before maintenance.

6 must be operating by a professional electrician to install

Product Packing Specification:

Contact Supplier