Manual Electrostatic Powder Coating Machine

• Quick and simple color change

• Enhanced coating quality of flat and complex parts

• Reduced operator fatigue

• Effective coating in corners and recesses

• Improved recoating ability

The electrostatic powder manual coating equipment with the COLO-06 manual powder gun is ideally suited for manual coating of objects in small series.

Technical Data

Electrical data

• Power range                                  220V/110V

• Frequency                                     50HZ /60HZ

• Temperature range in use                      -10 ℃+50 ℃







Powder Gun




• Gun weight:    ^^^                    500G

• Rated output voltage ^…                      24VDC

• Input voltage     ^^…                       - 200kv

• Maximum output current  ^…                   180Ua(max)

• Maximum output voltage^^                   0-100KV (  adjustable)   

• Maximum powder injection :^…                    600g/min

• Polarity ^^^                                negative (-)  







Pneumatic data




• Maximum input-air pressure ^^..                 10kg/cm

• Optimum input-air pressure^..                        6kg/cm

• Minimum input-air pressure   ^                      4kg/cm

• Maximum water vapor content or compressed air …..      1.4g/N m3

• Maximum oil vapor content of compressed air   ^..     0.1ppm

• Maximum compressed-air consumption^…            13.2 m3/h










-INSTALLATION

→Propery ground all equipment in the spray area to an earth ground and maintain this ground




→Remove all containers of volatiles from the spray area




→Establish and maintain a grounded area for the spray operator




→The gun of xseries must be connect to xcontrol unit










→OPERATION




→The operator should hold the gun in his bare hand




→If gloves are worm ,the palm should be out to assure skin to metal contact




→The operator should wear shoes with conductive shoes e.g leather




     Rubber shoes are not conductive .




→Ground the tip of the gun before cleaning or changing nozzles.




→When the gun is not in use , it should be hung so that the nozzle is within four inches of a grounded conductor




→The operator should wear a filter-type respiator anytime he is exposed to dusty conditions




→High pressure powder many cause injury ,Keep the rear switch  "off" position in no –use condiction










  MAINTENANCE




→Make a periodic confirmation of grounding to earh of all equipment in the spray area .




→Exercise good housekeeping practices , do not allow dirt or powder to accumulate on the feeder /powder unit , cable or gun.




→Keep the cabinet door

Brief introduction of powder coating

Powder coating is a type of coating that is applied as a free-flowing, dry powder. The main difference between a conventional liquid

paint and a powder coating is that the powder coating does not require a solvent to keep the binder and filler parts in a liquid

suspension form. The coating is typically applied electrostatically and is then cured under heat to allow it to flow and form a "skin". The

powder may be a thermoplastic or a thermoset polymer. It is usually used to create a hard finish that is tougher than conventional

paint. Powder coating is mainly used for coating of metals, such as "whiteware," aluminium extrusions, and automobile and bicycle

parts. Newer technologies allow other materials, such as MDF (medium-density fibreboard), to be powder coated using different methods.

The process of the coating

The process of the coating is like this :the powder is fluidized in the powder hopper. The injectors transport the powder through the hoses to the guns . The guns spray a powder/air mixture onto the workpieces.

The powder coating process involves three basic steps:

Part preparation or the pre-treatment

The powder application

Curing

Our COLO-668 model also can with different style hopper

contact with sonne

Skype:hicolosystem

Mobile: 0086-13396517032
Fax : 0086-571-86015003 
Zip : 310010 
E-mail:colo@colourspray.com