Waste tire recycling plants for rubber powder

Waste tire recycling plants for rubber powder

Process flows: waste tires--- circle cutting--- strip cutting--- slicing cutting--- magnetic separating--- separation—packaging—put in storage.

1. Tire ring cutting machine

Tire ring cutting machine is an alone accessory machine, it puts the tire which is greater than 650 type (both nylon and steel wire) flat on the machine, locking tire inside opening through up and down locking system, then putting alloy tools to target to the place of disintegration of tire to cut off the mouth and nation of tire, finished in 3 minutes. The power is 4kw; revolting speech is 40r/min, Shape dimension: 1.8m*1.3m*1.6m.

2. Tire strip cutting machine

Tire strip cutting machine make use of two round special cutting tools to combination running cutting. It can cut the tire of circle cutting into 3-8mm wide strip, to use for dicer cutting. The material of this machine's knife disk is special alloy structural steel (scientific name: Nine-chrome-silicon), diameter of knife disk isΦ390mm, hardness is 58-62GrS, more durable. With the hand grinding wheel cast when not sharp, power is 4kw, revolting speech is 45r/min, shape dimension: 1.3m*0.8m*1.65m.

3. Tire block cutting machine

Tire block cutting machine is prepared for the crush of host machine, Not only it makes the cutting strip-type waste rubber cut into about 3*8cm small pieces, but also can enter into host machine again through mutual use between sword and fixed knife, convenient to feed, high output and won't damage roller easily, power is 5.5kw, revolting speech is 380r/min,shape dimension: 1m*0.8m*1.4m. To pay attention to the space between sword knife and fixed knife when the machine is in operation, best to keep at around 0.1mm, so that the steel wire can be cut off.