Microfibre Super Mop Head Replacement Refill Cloth Pad Floor Cleaner Sweeper

Once you have created a long strip along the first wall, shim the plank from the end of the wall ¼-inch. Shim ¼ inch off the other wall as needed. Take a plank and turn it upside down. Place it against the end of your first row. Make a mark even with the groove and cut it, using a power miter saw. Now attach the last piece into place with a rubber mallet and tapping block/shoe. Shim it with a ¼ piece of wood.

Now you can begin to lay the next row. Go back to where you started and center a piece on the next row, so as to stagger the joints. Make sure the false grout lines up well. You will need to cut this piece with the miter box. You may need to undercut the length. This will ensure you have a correct fit. Re-cut as needed until it fits perfectly. Continue along the line adding planks as needed, staggering all joints and aligning the false grout lines perfectly. Tap each plank into place with the rubber mallet and tapping block/shoe as you continue down the line. As you add each piece into place, continually check that the shims are in place and a ¼-inch gap is maintained along each wall.

Mark around all pipes and protrusions with a carpenter pencils. Lay the pencils width against the object you are trying to scribe. Place the tile lament flooring under the pencil and slowly scribe the plank. You can clamp the plank to a sawhorse and cut it using a jigsaw or coping saw. A compass will work well for large protrusions or awkward angles. You may also need to create a template for multiple intricate cuts. Cut a piece of cardboard to the exact size of the plank you need. Use a utility knife to trim the piece until it fits perfectly and then transfer the pattern on the cardboard to the tile laminate floor.

Once the floor is all done and snapped into place, make sure it is still shimmed ¼ inch around all walls and cabinets. Attach the base on top of the flooring to the walls as needed. If the base is already down, then shoe molding is required to close the gap between the walls and the flooring. Finally install all of the transition strips. Cut each strip to length to fit between doors and openings. You can glue them into place using liquid nail or other similar wood glue. Wipe away any excess glue with a damp sponge. Now your floor is complete and ready to be enjoyed!