30cm Seal Length Surgical Sterilization Sealing Facility

a. Roll-holder tube   b. Roll-holder   c. Cutting blade runner   d. Indicator

e.  Sealer arm   f. Socket for power cord g. Power switch

Before using:

a. Position the Sealer on a flat surface with sufficient working space around it.

b.  Do not install the machine next to sinks or anything similar in order to avoid contact with water and the short circuit of the electrical system.

c. Avoid proximity to sources of heat.

d. Install the machine in an area with normal ventilation.

e.  Make sure that the power cord is not bent and that it is free of obstruction up to the electric socket.

3-Installation:

a. Remove the sealing/cutting station and the roll-holder with care from the packaging.

b. Insert the roll-holder into the sealing & cutting station, Tighten the three screws  with the key until they are fully tightened.

c. Insert roller-holder tubes on the roll-holder, if necessary by turning the tube.

(a) Connect the power cord to the power connector which is on the back side of the sealer, check if the voltage of your equipment matches the voltage of the local electrical network.

(b) Switch the sealer on by using the power switch on its back side and adjust the sealing temperature through the temperature selector on its right side according to the thickness of the material to be sealed. When the green LED goes off (after around 2 minutes) the sealer will be ready to be used.

(c)Place the roll on the holder. The beginning of the roll shall be inserted through the back side, between the pressure bar and the sealing bar always with the paper side down (resistance's side)and the plastic side up (directly under the upper pressure bar). Pull the sealer arm towards the operator and press it down softly until it is locked. Exaggerated pressure may break the sealer arm and this kind of damage is not covered by the warranty. The sealing time (around 4seconds) must be manually controlled by the user. Note: If the sealing temperature is too low or too high the sealing might be inefficient (the envelopes may be stuck to the sealing area when they are pulled or be visibly badly-sealed). To correct this, adjust the timer properly. Once adjusted it is not necessary to perform any other adjustment to continue sealing.

(d) To cut the packages, still with the arm locked, slide the blade from one side to the other, raise the sealer arm and remove the envelopes.Note: If the blade knob is pulled slowly the paper may crease and the cutting will not be adequate. To make it more precise, pull the blade knob quickly. If necessary, slide the cutting blade more than once.

3-Payment details
T/T, L/C & west union acceptable.

4-Shipment