Product information
This elegant Security and high practical mobile alarm holder, with UV surface treatment
technology, which greatly promoted the launching of experiential marketing, it also
benefits the product performance and security.
The anti-theft alarm stand for mobile has the characteristics of easy operation, low
cost, high effect, and benefits to improve the stores image and performance rapidly.
It applies to cell phone supermarkets, telecom mobile unicom business hall, electronic
digital city, digital camera store, GPS counters, MP4 counters, home appliance stores,
supermarkets and all kinds of small and medium-sized electronic digital product
exhibition hall of the security guard against theft.
This mobile security alarm reveal a beautiful and easy, high-grade practical, and the
surface of the UV processing technology, greatly promote the experience marketing, the
launch of the help to track the performance of promotion and the product
safety.
The security alarm display holder will alarm in following conditions:
1) Circuit break resistance
2) Short circuit resistance
3) Other circuit-replacing resistance
4) Prying and cutting resistance
5) Remove the sensor
6) Cut the spring wire
7) Put out the connector
8) Put out power connector
9) When remove or pry the stand on the bottom
Products installation
1.Clean the display case, then turn on switch on the bottom of Security alarm holder for
mobile host, adhere the bottom of the anti-theft frame with 3M adhesive tape to the
exhibit cabinet. Or use two anti-theft screws to connect the cabinet frame and tighten
the exhibition (open f the screw hole cover firstly)
2.Connect the charger of Security alarm holder for mobile with the alarm host, the other
end into the power socket in preparation for a fixed monthly charge.
3.Tear off the 3 adhesive tape from the Anti-Theft Terminal product display and paste
exhibits back fastened
4.Tear off 3M adhesive from the sensor probe, stick tight with the obverse of the
product
5.Take out the Infrared remote control board , tear off the battery insulation sheet
underneath. Press the ON key , the host switch on ,enter the preset alarm status
6.The installation is set up