HDPE Socket Fusion Equal Tee Pipe Fittings

HDPE Socket Fusion Equal Tee Pipe Fittings

***Advantages and welding of PE pipe fittings:

PE pipe fittings is light, which is more common for partial application pe80 pe100 grade level and two standards , including :

PE80 density of about 0.94 g / cm 3, PE100 density of about 0.96 g / cm 3 ;

Easy thermoplastic - easy to process ( such as injection molding, extrusion molding

Remanufacturing easy recycling

Good resistance to radiation and chemical stability

Good resistance to cold , the temperature can be -40 ℃ to

Excellent electrical insulation properties , is not affected by electrolytic corrosion

Malleable - extended break PE80> 700% PE100> 600%

Anti- erosion resistance - 8 times better than steel

Approximately half of the low thermal conductivity of glass

Smooth surface , unlike the role of metal pipes rust easily with oxygen crusts

pe pipe connection into fused pipe connections and fittings connected to melt , the more ordinary side, the other , as well as socket connections, this method is applied to a small size.

1 , fused connection : Follow these steps: First check , and then is cut pipe , pipe fittings joints clean , scrape the oxide layer , connecting the two parts of the tube and pipe fittings , calibration welder , welding parameter adjustment in accordance with the welding voltage, welding Dimensions , electricity, welding, and then finally cooled.

2, the hot melt connection : the inner surface of the pipe surface and the pipe is inserted while the welding is non-rotating die head is heated for a few seconds , then quickly removed and welding device , the heat pipe has a fast vertical insertion tube , packing, cooling to .

3 , socket connections, relatively simple, not elaborate here .

***Quality and Inspection of HDPE socket fusion equal tee pipe fittings

1.Check the socket member and the socket member whether positive 

2.Between the socket member from the socket member and the molten material is extruded on the outer circumference should be uniform throughout the 

3.The welding area should not have impurities, shrinkage or other damage 

4.Should dissolve some phenomena soldering temperature is too high or too much pressure caused appear: 

If the wall collapsed, curling too large or shape is not correct and so on.

***Specifications of HDPE Socket fusion equal tee Pipe Fittings

Size	D(mm)	H(mm)	L(mm)
T20	26	26	52
T25	32	30	60
T32	41	35.5	71
T40	51	42	84
T50	63	50	100
T63	79	60	120
T75	88	63	125
T90	105	75	155
T110	127	90	190