Technical data:
Laser Range :5M
Laser power Output : <1mW
avelength :650m
Operating Voltage :4.5V
Batteries included :3coins,1.5v
Laser Class 2
Drilling machine size can be used :Max diameter 10mm
Use
1.Remove the protective hood.
2.Find the correct points.
1)switch on the laser switch
2)Attach the machine to the flat surface .Make the bubble in the vial to the middle point.
To line in horizontal ,the bubble should be in the middle place of horizontal vial,
3)Switch on the machine,make it attach on the surface automatically.And mark the point to be drilled. The laser part can be detached from the appliance and used separtely.
3.Press the release button and take down the appliance after marking.
4. Insert the drill through the drill opening and place it at the marked point.
5. Place the machine on the wall and switch on the appliance.Press to briefly see that the appliance automatically retained to the surface.Leave the appliance switched on during the drilling process!
6.Remove the drill from the machine .
7.Press the release button and take down the appliance from the wall.
8.Press the dirty container cover at its locking tabs on both side and remove it.
9.Empty the dirty container and replace the cover.
10To continue working ,repeat the above steps.
