Medium bus spray booth

1.Booth design

The booth panels wall thickness: 50 mm are made of 0.476mm steel and plastic plates with injected fillings of heat insulation foam materials in the middle section. This provides better heat retention and sound proofing The booth ceiling panels are made of rigid folded electric galvanized steel plates frame. All the panel joints are lined with aluminum strips which provide better sealing.

2.Door design

The booth front entrance has three doors(foldable) and one safety exit/ service door at the side. All doors are made by bending methods and the middle sections are reinforced with 1.5mm thick steel plates frame. During installation M8bolts and nuts are needed to fix up. The sight glass is of oblong shaped.

3.Air intake system

One unit 7.5kw motor direct drive blower, 25000m3/h. The heat exchanger is made of stainless material thickness of 1.5mm which features more heat dissipating surface, better heat exchange and better burner efficiency. The burner is an Italian made brand "RIELLO" mode 40-G20 and the air valve uses "BELIMO" electronic control unit.

4.Air exhaust system

One uint 7.5kw derict dive blower, 25000m3/h.

5.Lighting system

At both(left and right) corners of the booth ceiling, there are 5 sets of 45 degree mounted lights. Each set consist of 4 pieces 40w hilips lamp. At the middle of section of booth(left and right) side panels, there are 6 sets of lightings. Each set consists of 2 pieces 18w philips lamps. Finally at th midsection of the rear end of the booth have 2 sets super bright lights.

6.Ceiling filter system

It consists of 2 rows of extra heavy duty steel grid covers and below it lay the filters which filters th out going air that exhaust out to the exhaust fan.

7.Control system

Baking process auto temperature control and shut off after completion.

8.Suitable vehicle types

Passenger cars and vans.

Contact Supplier