Router and WiFi function, triple-play (Data+VOIP+CATV+WiFi), L2 switch on LAN side, L3 router function on Ethernet WAN side, FTU, dual management platforms for VoIP and Ethernet data
OnAccess43x Series Triple Play Optical Network Unit (ONU) is designed to deliver ultra broadband internet data access, high quality voice over IP telephony and full-spectrum CATV services for Fiber-to-the-Home (FTTH) access network.
OnAccess43x Series ONU includes a fiber termination unit (FTU) and an active equipment (AE). The fiber can access the FTU from the back, top, bottom, left or right of the unit, and the fiber connectors in the fiber tray are protected from dust/dirt and physical damages well over their life time. The FTU is also designed to make AE installation easy, fast and time independent from FTU installation. This patented FTU structure of FirstMile enables easy deployment and maintenance by network builders. It is also a robust and cost-effective solution for terminating fiber access, with the flexibility to install the AE together with the FTU, or to install the AE later when the end user wants to activate their services.
OnAccess43x ONU provides two independent management platforms for VoIP service and Ethernet data service respectively, which allows different network operators to provision the services independently.
OnAccess43x ONU offers WiFi access in addition to the conventional wired Internet access. OnAccess43x Series ONU has FirstMile's Customer Orientated ONU Load (COOL) capability. It can build a smart factory default configuration load on the ONU based on the customer's needs. This COOL capability provides the network operators with a tool to preset and/or reset the default configuration on the ONU, which can bring down their operational cost.
The table below is shown all types of OnAccess43x Series ONU:
| Type | Model | Services | IP Configuration | WAN Uplink Optional | Port or Function Available | Backup Battery | Fiber Tray |
|---|
| Single Fiber | Dual Fiber | RJ45 | 4 RJ45 Ports of 10/100M TX | CATV | VOIP | WIFI |
|---|
| Advanced Router ONU | OnAccess431S | Data+WiFi | Single IP | √ | | √ | √ | | | √ | Optional | Yes |
| OnAccess432S | Data+CATV+WiFi | √ | | √ | √ | √ | | √ |
| OnAccess432D | Data+CATV+WiFi | | | √ | √ | √ | | √ |
| OnAccess434S | Data+CATV+VOIP+WiFi | Dual IP(For data and VOIP each) | √ | √ | √ | √ | √ | √ | √ |
| OnAccess434D | Data+CATV+VOIP+WiFi | | | √ | √ | √ | √ | √ |
| OnAccess435S | Data+VOIP+WiFi | √ | √ | √ | √ | | √ | √ |
Layer 3 Operation
- High speed Layer 3 routing
- Network Address Translation (NAT)
- Firewall
- DMZ
- Static and dynamic IP address assignment
Layer 2 Ethernet Switch
- Four 10/100Base-TX Half/Full duplex layer 2 switch ports
- up to a 2048 MAC address table (4-way hashing)
- 6K X 64 bits packet buffers are divided into 192 blocks of 256 bytes each
- Store & forward architecture and performs forwarding and filtering at non-blocking full wire speed with auto aging function
- 802.3x flow control for full duplex and a backpressure function for half duplex with bandwidth control function
- 802.1p, port-base QoS package classification with 4 priority queues
- Packet lengths up to 1518/1522 (Default)/1536/1784 bytes in maximum
- 802.11a/b/g WLAN supports up to 54Mbps transmission rate
- Secure transmitting encryption by either WEP,WPA,TKIP,AES
- Configuration and management by Web/HTTP
- DHCP option 66 and 67 Auto-Configuration management for VoIP configuration
Telephony with VoIP (Optional)
- Two POTS ports to provide VoIP telephony and T.38 fax services complying with SIP telephony signaling protocol
- Carrier-grade voice quality with voice activity detection, comfortable noise generation and line echo cancellation
- Full range of Class 5 services, such as call waiting, 3-party call, call forwarding and caller display
Optical CATV Receiver (Optional)
- Wide 40 MHz ~ 860 MHz bandwidth supports CATV analog channels or a combination of analog and digital channels including HDTV broadcast
- Excellent RF frequency and distortion characteristics for high linearity
- Internal proprietary impedance match circuitry with one 75Ω coaxial-cable output port
- High sensitivity of 75 or 88 dBuV RF output at –3dBm optical input
- Single-mode fiber
- high return loss optical interface with receptacle Wide range of optical input power of -10 ~ 0 dBm
Wireless Access Point Option
- 54 Mbps data transmission rate in 2.4GHz ISM band
- Compatible with wireless IEEE802.11a, IEEE802.11b and IEEE 802.11g standard product
- Advanced wireless security
Fiber interface option
- Single-fiber option - Integrated wavelength division multiplexer (WDM) module in the AE of ONU housing with one SC/APC receptacle connector for access fiber with CATV overlay
- Dual-fiber option - One fiber for Ethernet down- and upstream and the other for CATV downstream
Technical Data
| Fiber type | single mode 9/125 μm |
| Optical WAN connector | SC/APC receptacle |
| Optical wavelength | 1280 … 1550 nm |
| Optical input power | Typical > -6dBm required, -8 dBm @ CNR = 48 dBc |
| Optical return loss | ≥ 40 dB |
| RF connector | F female |
| RF impedance | 75 Ω |
| RF return loss | ≥ 12 dB |
| RF bandwidth | 40 … 860 MHz |
| Flatness | ± 1 dB |
| Receiver noise current | 4,0 pA/√Hz |
| RF output level | 88 dBμV @ -3dBm input power |
| CSO | ≥ 65 dBc |
| CTB | ≥ 65 dBc |
Optical Transceiver Module for Dual fiber version (Model:OnAccess43xD)
| Fiber type | single mode 9/125 μm |
| Package type | 1x9 or SFP |
| Optical WAN connector | 1 x SC/PC receptacle |
| Ethernet wavelength TX | 1310nm |
| Ethernet wavelength RX | 1550nm |
| Optical sensitivity | ≥ -31 dBm |
| Optical output power | ≥ -15 dBm |
| Standard compliance | IEEE802.3u 100BASE-FX |
Optical Transceiver Module for Single fiber version (Model:OnAccess43xS)
| Fiber type | single mode 9/125 μm |
| Package type | 1x9 |
| Optical WAN connector | 1 x SC/APC receptacle |
| Ethernet wavelength TX | 1310nm |
| Ethernet wavelength RX | 1310nm |
| Optical sensitivity | ≥ -31 dBm |
| Optical output power | ≥ -15 dBm |
| Standard compliance | IEEE802.3u 100BASE-FX |
Interface Type
| Optical WAN Interface | - Dual fiber option (Model: OnAccess43xD)
- CATV Input Port 1 x SC/APC receptacle
- Ethernet data WAN Port 1 x SC/PC receptacle
- Single fiber option (Model: OnAccess43xS)
- CATV and Ethernet data WAN Port 1 x SC/APC receptacle
|
| LAN Twisted Pair Interface | 4 x RJ-45 |
| Cable Television Interface | F female, 75 Ohm |
| Telephony Interface | 2 x RJ-11, POTS ports |
Protocols and Standards
- IEEE802.3 10Base-TX Ethernet
- IEEE802.3u 100Base-TX fast Ethernet
- IEEE802.3u 100Base-FX fast optical Ethernet
- IEEE802.3ah 100Base-BX10 fast optical Ethernet (Single bi-directional fiber)
- IEEE802.3x flow control
- IEEE802.1p priority
- IEEE802.1q VLAN
- SIP v1 RFC2543 and SIP v2 RFC3261
- G.711, G.723, G.726, G.729, GSM
- TCP/IP, DHCP, RTP, RTCP, HTTP, FTP
Management
- DHCP and static fixed-IP options
- Integrated Web Server, SNMP v1/v2/v3, telnet
- TFTP remote management software upgrade and auto provisioning
Physical and Environmental
| Dimensions | 263mm x183mm x 53 mm (268mm x213mm x 56mm with cover) |
| Net weight | 1.3 Kg |
| Installation | Indoor /wall mountable |
| Operating temperature | 0~50℃ |
| Storage temperature | -20~85℃ |
| Humidity | 5%~95% (non-condensing) |
| Power Supply | 12VDC/15A adopts external power supply adapter |
| power consumption | 9W |
Approvals
| Safety | EN60950 |
| Emission | EN55022 1998 Class B, EN55011 |
| Immunity | EN55024 1998, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6, EN61000-4-11 |
| ESD | EN61000-4-2 |
Reliability
Ordering Information
- OnAccess431D: Dual Fiber, Router+WiFi(WiFi card)
- OnAccess432D: Dual Fiber, Router+WiFi(WiFi card)+CATV
- OnAccess434D: Dual Fiber, Router +WiFi(WiFi card)+CATV+VOIP
- OnAccess435D: Dual Fiber, Router +WiFi(WiFi card) +VOIP
- OnAccess431S: Single Fiber, Router+WiFi(WiFi card)
- OnAccess432S: Single Fiber, Router+WiFi(WiFi card)+CATV
- OnAccess434S: Single Fiber, Router +WiFi(WiFi card)+CATV+VOIP
- OnAccess435S: Single Fiber, Router +WiFi(WiFi card) +VOIP
