clamping for stamping presses
It is in the heart of this change with no hidden time to fix clamps, make adjustments or test between 2 production batches. Made up of 2 magnetic modules, it's easy to install, and integrate into the existing machine and controls.DM-QMC is easy to install. Using bolts to mount magnetic plates to existing T-slots or tapped holes. Its modularity allows adaptability for any need. No modifications to the press are required. Bigger dies can be used in smaller presses.
DM-QMC control interface is small and installs easily The system uses several safety devices to avoid accidental mag or de-mag:
- The buttons must be activated simultaneously (SAFE function).
- The interlock key to prevent mag/demag by unauthorized personnel.
- Bottom dead center channel enable.
The patented circuit creates a concentrated clamping force directly into the piece to be clamped. Permanent-electro magnets need power supply only during activation (MAG) and de-activation (DEMAG) phases; even in
case of power failure or cut cables, the holding force does not change.Permanent-electro technology provides a full and complete demagnetization: after the job is done the piece doesn't retain residual magnetism.